Rhythmedics® Bio-Pulses™

Interrupt Harmful ElectroMagnetic Pollution (EMI)

Oscilloscopic Comparisons to the SRT-3 Q-Link

Q-Link’s pendant has been touted for its ability to transform harmful EMI (ElectroMagnetic Interference) into positive energy, supposedly enabling its wearer to stay energized and focused. Q-Link is a passive device, which when viewed from the front appears to have a simple coil of copper wire wound around it center. Rhythmedics instruments are active devices emitting Fibonacci based Bio-Pulses that actively interrupt harmful EMI Pollution. NuTesla acquired a new SRT-3 Q-Link and using NuTesla’s state-of-the-art laboratory conducted a series of tests comparing the measurable and viewable affects of both the Q-Link and Rhythmedics to disrupt EMI Pollution from three common household electrical products; A) 5.8 GHz Cordless Phone, B) 12 volt Plug-in Wall Transformer used to recharge electronic devices, and C) desktop fluorescent lamp’s power supply. Three images are displayed for each electrical product tested. The first image shows the raw EMI Polluter source, the second shows the EMI Pollution with the Q-Link between the probe and source, and the third shows the EMI pollution with the Rhythmedics Instrument between the probe and source. In every case the Q-Link shows no affect on the EMI Pollution, whereas the Rhythmedics Instrument clearly interrupts the EMI Pollution source.

1. CORDLESS PHONE EMI (First Image No Protection, Second Image Q-Link and Third Image Rhythmedics Bio-Pulses)

2. WALL TRANSFORMER EMI (First Image No Protection, Second Image Q-Link and Third Image Rhythmedics Bio-Pulses)

3. FLUORESCENT LAMP POWER SUPPLY EMI (First Image No Protection, Second Image Q-Link and Third Image Rhythmedics Bio-Pulses)

Notes: All measurements were made with a Tektronix TDS 3034 Digital Phosphor Oscilloscope. A 10 milliHenry ferrite core inductor with a 10,000 ohm termination resistor was used as the probe. Measurements were made at a distance of 1 inch from the EMI Pollution source to eliminate ambient EMI Pollution sources. Once a raw EMI signal was captured on the digital oscilloscope, the SRT-3 Q-Link was inserted between the Polluter source and the probe and the second image was captured. Then the Rhythmedics Instrument was placed between the EMI Polluter source and probe and the third image was captured. All settings for the Oscilloscope are displayed on its screen.

Conclusion

The images above clearly show the Q-Link makes no observable changes to the EMI Pollution from common household sources. Whereas the images clearly show the Rhythmedics Bio-Pulses interrupts the continuous EMI Pollution. This is critical as studies of EMI have shown it is necessary to disrupt the continuity of the EMI stream in order to prevent that aspect of it from adversely affecting the health of humans and animals. All Rhythmedics Instruments create Bio-Pulses that effectively interrupts harmful EMI Pollution as shown above.